How To Register Scan In Scene

Processing and Registering Scans with SCENE

Last updated
Save as PDF

Overview

Processing and registering scans in SCENE is an intuitive procedure that begins after you lot have imported your scan data.

Process Scans

Open the project.
Click Projection on the SCENE ribbon.
Click Process Scans under Processing.
Select the scans to process and click Configure Processing.
Arrange the processing settings every bit desired.
Click Start Processing.

If you get a screen that says processing failed it is likely that the SCENE couldn't register the scans on its ain. This could be for a couple of different reasons:

There may not be enough overlap between the scans.
The surfaces in the scene may exist difficult to register, like bravado trees and tall grass.
Rooms or surfaces in one surface area of the scene may look like to other areas in the scene which tin throw off registration. Mirrors in the scene could duplicate a room.

Register Scans

Fifty-fifty if the scans registered successfully during the project transfer, you lot will need to view and verify the registration.

On the project page, click Registration to check.\
Click Verify Registration or the Scan Report icon.
On the Register and Verify folio, utilise the view toolbar at the lesser to compare your scans from different angles.
If the scans are registered correctly, click Yes and Finish.
If not, click No and Finish. You will exist directed to register the scans again.

You tin can register scans later, past clicking the Registration tab on the SCENE ribbon.

Legacy Tutorials